Loading
 

 

Oregon Bulletin

August 1, 2012

Department of Consumer and Business Services, Building Codes Division, Chapter 918

Rule Caption: Mid-cycle code amendment for recreational vehicle construction.

Adm. Order No.: BCD 6-2012

Filed with Sec. of State: 6-27-2012

Certified to be Effective: 7-1-12

Notice Publication Date: 5-1-2012

Rules Amended: 918-525-0042

Subject: This rule amends one of the standards for the construction, conversion, alteration, and repair of recreational vehicles in Oregon. This rule amends the 2011 NFPA 70, National Electrical Code (NEC), Article 551-42 (C) to allow a sixth circuit in a 30 ampere power supply assembly.

Rules Coordinator: Stephanie Snyder—(503) 373-7438

918-525-0042

Amendments to the Adopted Minimum Safety Standards

(1) Amend NFPA 1192, Section 5.4 Fuel-Burning Appliances by adding the following language after Section 5.4.1. “Solid-fuel-burning appliances shall not be installed in recreational vehicles, except where specifically permitted in these rules.”

(2) Amend ANSI 119.5 as follows:

(a) Amend Chapter 1 by inserting the following language after Section 1-5.

(A) Each loft area shall have a minimum of one electrical light fixture and a convenience receptacle.

(B) Each enclosed stairway shall have a light fixture that is controlled by switches from both the top and the bottom of the stairway. The light fixture in subparagraph (A) of this rule may be used to serve this purpose.

(b) Amend Section 2-6 Fuel-Burning Appliances by inserting the following language after Section 2-6.1. “Wood-burning stoves, wood-burning fireplaces and pellet fired appliances may be installed if they are approved and listed for recreational vehicle use or for manufactured home use and installed according to the manufacturer’s installation instructions.”

(3) Effective April 9, 2012, amend NFPA 70, Article 551.42 (C) by adding a new exception. “Exception 2: A sixth circuit, without employing an energy management system, shall be permitted to serve only the power converter provided the combined load of all six circuits does not exceed the allowable load permitted by a five-circuit system.”

[Publications: Publications referenced are available from the agency.]

Stat. Auth.: ORS 183.325 - 183.410 & 446.003 - 446.285
Stats. Implemented: ORS 446.185
Hist.: BCD 25-2008, f. 10-31-08, cert. ef. 11-1-08; BCD 1-2010, f. 3-1-10, cert. ef. 4-1-10; BCD 26-2011, f. 9-30-11, cert. ef. 10-1-11; BCD 3-2012(Temp), f. 4-6-12, cert. ef. 4-9-12 thru 9-30-12; BCD 6-2012, f. 6-27-12, cert. ef. 7-1-12


 

Rule Caption: Establishes specialized inspector training and certifications as authorized by House Bill 3462 (2009).

Adm. Order No.: BCD 7-2012

Filed with Sec. of State: 6-27-2012

Certified to be Effective: 7-1-12

Notice Publication Date: 6-1-2012

Rules Adopted: 918-098-1590, 918-098-1591

Rules Amended: 918-098-1510, 918-098-1530

Subject: HB 3462 (2009) authorized the Building Codes Division to create a program for training, qualifying, and certifying individuals as specialized building inspectors authorized to perform inspections and enforce portions of Oregon’s specialty codes. These rules establish new inspector certifications to cover limited commercial and other multidisciplinary inspections that are not presently independently authorized by the division’s existing inspector certifications. These rules establish the criteria for the Specialized Finals Inspector certification. This multidisciplinary certification allows an individual to perform all residential final inspections.

Rules Coordinator: Stephanie Snyder—(503) 373-7438

918-098-1510

Purpose and Scope

(1) The specialized inspector certification program, in OAR 918-098-1510 through 918-098-1591, establishes a program for training, qualifying and certifying individuals as specialized building inspectors authorized to perform inspections and enforce portions of the state building code. Inspector certifications cover limited commercial and other multidisciplinary inspections that presently are not independently authorized by the division in existing inspector certifications.

(2) Specialized inspectors may, after receiving certification issued under these rules, conduct inspections as provided in these rules. These rules apply to applicants and certificate holders, training providers, and participating jurisdictions for the purposes of administering and enforcing the restrictions and requirements under these rules.

Stat. Auth.: ORS 455.720, 455.730 & 455.735
Stats. Implemented: ORS 455.720, 455.730 & 455.735
Hist.: BCD 10-2011(Temp), f. 4-15-11, cert. ef. 5-1-11 thru 6-30-11; BCD 15-2011, f. 6-30-11, cert. ef. 7-1-11; BCD 25-2011(Temp), f. & cert. ef. 8-18-11 thru 10-1-11; BCD 27-2011, f. 9-30-11, cert. ef. 10-1-11; BCD 2-2012(Temp), f. & cert. ef. 3-1-12 thru 6-30-12; BCD 7-2012, f. 6-27-12, cert. ef. 7-1-12

918-098-1530

Training Programs

(1) Approved applicants must complete an appropriate division-approved training program and pass a division-approved examination for the desired specialized certification. Training program requirements are stated in OAR 918-098-1560 for the Specialized Solar Photo-Voltaic Inspector Certification, in OAR 918-098-1570 for the Specialized Plumbing Inspector Certification, and in OAR 918-098-1580 for the Specialized Electrical Inspector Certification, and in 918-098-1590 and 918-098-1591 for the Specialized Finals Inspector Certification.

(2) Instructor Qualifications. Specialized certification training course instructors must be approved by the division under these rules.

(a) Training course instructors may apply for approval as part of the course approval process or independent of the course approval process.

(b) Approved training course instructors must be qualified by training, licensure, and experience to teach the subject matter and supervise the corresponding fieldwork training inspections of a specialized inspector certification training program.

(c) Approved fieldwork supervisors must be qualified by training, licensure, and experience to perform the specialized inspector certification fieldwork inspections being performed.

(d) Division staff teaching training courses of supervising related fieldwork in the normal course of their duties are considered approved instructors for the purposes of these rules.

(3) Fieldwork Training. A specialized inspector certification applicant is eligible to perform the required fieldwork training after the applicant has begun the required academic coursework.

(4) Fieldwork Supervision. All specialized certification fieldwork training must be supervised and verified by an inspector with a valid Oregon Inspector Certification required to conduct the inspections being performed.

(a) An applicant’s fieldwork training must be documented on a division-approved form and signed by the inspector who supervised the inspections.

(b) An inspector supervising and verifying an applicant’s fieldwork training may not be qualified to conduct the inspections performed based solely on a specialized inspector certification issued according to these rules.

(5) Fieldwork Training Approval. A specialized inspector certification applicant must submit proof of completed fieldwork training to the division for verification and approval, and issuance of specialized inspector certification.

(6) Examination Approval. A specialized inspector certification applicant is eligible to take a certification examination after the division receives proof that the applicant has successfully completed the required academic coursework and fieldwork training.

Stat. Auth.: ORS 455.720, 455.730 & 455.735
Stats. Implemented: ORS 455.720, 455.730 & 455.735
Hist.: BCD 10-2011(Temp), f. 4-15-11, cert. ef. 5-1-11 thru 6-30-11; BCD 15-2011, f. 6-30-11, cert. ef. 7-1-11; BCD 25-2011(Temp), f. & cert. ef. 8-18-11 thru 10-1-11; BCD 27-2011, f. 9-30-11, cert. ef. 10-1-11; BCD 2-2012(Temp), f. & cert. ef. 3-1-12 thru 6-30-12; BCD 7-2012, f. 6-27-12, cert. ef. 7-1-12

918-098-1590

Specialized Finals Inspector Certification

(1) Scope of Activities and Authority. Specialized finals inspectors may upon receipt of this certification conduct final inspections of one- and two-family dwellings constructed under the Oregon Residential Specialty Code as provided by the Director through rule.

(2) Procedure for Qualification. An applicant for certification under this rule must meet the general qualifications in OAR 918-098-1520, 918-098-1530 and this rule.

(3) Experience, Education, and Training Requirements.

(a) As a condition of entering a specialized finals inspector training program:

(A) Applicants must hold valid Oregon Inspector Certification and at least one appropriate certification to perform either residential or commercial mechanical, structural, electrical or plumbing inspections in Oregon; and

(B) Been employed as an inspector and performed inspections of the Oregon Structural or Residential Specialty Codes, Oregon Mechanical Specialty Code, Oregon Electrical Specialty Code, or Oregon Plumbing Specialty Code for a minimum of one year prior to applying for the Specialized Finals Inspector Certification.

(b) Applicants must complete a specialized finals inspector training program that meets the minimum requirements established by the division, and consists of:

(A) Classroom coursework; and

(B) Required fieldwork inspections

(c) After completion of the classroom coursework and required field inspections, applicants must successfully pass a division-approved examination.

(d) Certification. Upon completion of all training and after passing a division-approved examination, the division will certify an applicant as qualified to perform specialized finals inspections, and issue the appropriate documentation.

Stat. Auth.: ORS 455.720, 455.730 & 455.735
Stats. Implemented: ORS 455.720, 455.730 & 455.735
Hist.: BCD 2-2012(Temp), f. & cert. ef. 3-1-12 thru 6-30-12; BCD 7-2012, f. 6-27-12, cert. ef. 7-1-12

918-098-1591

Specialized Finals Inspector Certification Scope of Authority

(1) Specialized finals inspectors may upon receipt of this certification conduct final inspections of one- and two-family dwellings constructed under the Oregon Residential Specialty Code as provided in this rule.

(2) A certificate holder may conduct final inspections in residential dwellings and accessory structures of structural components and mechanical, plumbing, and electrical systems where the item inspected was previously inspected and approved, or where a previous inspection and approval is not required, and the item is otherwise ready for a final inspection, except:

(a) Electrical systems with a service in excess of 400 amps;

(b) Emergency and stand-by power generation equipment;

(c) Solar photovoltaic installations; and

(d) Swimming pools.

(3) Where a component or installation is sufficiently complex, a building official may limit the authority of a Specialized Finals Inspector to less than the scope contained in this rule.

Stat. Auth.: ORS 455.720, 455.730 & 455.735
Stats. Implemented: ORS 455.720, 455.730 & 455.735
Hist.: BCD 7-2012, f. 6-27-12, cert. ef. 7-1-12

Notes
1.) This online version of the OREGON BULLETIN is provided for convenience of reference and enhanced access. The official, record copy of this publication is contained in the original Administrative Orders and Rulemaking Notices filed with the Secretary of State, Archives Division. Discrepancies, if any, are satisfied in favor of the original versions. Use the OAR Revision Cumulative Index found in the Oregon Bulletin to access a numerical list of rulemaking actions after November 15, 2011.

2.) Copyright 2012 Oregon Secretary of State: Terms and Conditions of Use

Oregon Secretary of State • 136 State Capitol • Salem, OR 97310-0722
Phone: (503) 986-1523 • Fax: (503) 986-1616 • oregon.sos@state.or.us

© 2013 State of Oregon All Rights Reserved​